OSH Park
Shared projects
USB FPGA v2.0
by
jshamlet.
4
layer board of
2.76x1.66
inches
(70.00x42.06
mm).
Shared on
February 13th, 2014 21:34.
USB-enabled FPGA development board
Spider Board
by
dwc238.
2
layer board of
1.31x1.31
inches
(33.15x33.15
mm).
Shared on
February 13th, 2014 20:38.
Control Board for Spider Robot
BLF TINY10
by
Mattaus.
2
layer board of
0.42x0.42
inches
(10.62x10.62
mm).
Shared on
February 13th, 2014 09:53.
10mm Nanjg 105C compatible LED/flashlight driver.
- Diode D1 is a BAT54.
- C1 is 10 uF.
- Resistors are 19.1K and 4.7K, 1%
- Regulator chips are AMC7135
- Processor is ATTINY13 or similar
LED connects to the + and - holes.
Outer ring is ground. Battery plus connects to + from the reverse side.
The driver mode configuration “stars” are marked 2 to 4 on the MCU side of the driver.
BLF discussion thread: http://budgetlightforum.com/node/24953#comment-550914
j201 converter
by
Clayford.
2
layer board of
0.30x0.27
inches
(7.65x6.86
mm).
Shared on
February 13th, 2014 05:16.
sot23 to-92 I did not design this, only shrink it as much as possible. Use resistor leads not SIL headers.
Dual 7 Segment Display
by
brodyf42.
2
layer board of
0.94x0.88
inches
(23.90x22.40
mm).
Shared on
February 13th, 2014 00:26.