You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 Re: Bug Reports » No support for portait screens » 2017-04-23 16:43:51
Having the same issue.
I tried editing the resolution, which gives the correctly rendered images in NanoDLP, but then when I run the print it's rotated 90 degrees on the printers screen.
Editing config does not seem to help either, for some reason.
#2 Re: Feature Requests » Preview Plate layers on printer LCD » 2017-04-20 07:15:47
Fantastic 
My use-case is before a print, I just need to check the orientation and scale is correct. I could do this by clicking Start print, but almost every time that ends up with me having to force reboot NanoDLP because it's unable to stop the print.
#3 Feature Requests » Preview Plate layers on printer LCD » 2017-04-18 06:56:27
- atlemo
- Replies: 6
This is not a copy of http://www.nanodlp.com/forum/viewtopic.php?id=493
What I'd like is this:
When I open a plate and go through the layers, I'd like a button to preview the current layer on my printers LCD screen.
Cheers.
#4 Re: Help and Support » Flipped plate? » 2017-04-11 11:47:33
Oh, btw; is it not possible to create new plates while printing? Right now it's just generating missing images.
#5 Re: Help and Support » Flipped plate? » 2017-04-11 11:35:37
Ok, thanks. I manually bypassed it now by just remoing the "min-value" from the markup.
In the middle of a print, but I'll try the latest beta once it's finished.
#6 Re: Help and Support » Flipped plate? » 2017-04-11 11:16:51
hm, I'm unable to save the change, it just says "Value must be greater than or equal to 0", but I can't see where it's supposed to go. Which number it's talking about.
My Y-resolutions is 0,000000, though. I don't think I should change that?
#7 Help and Support » Flipped plate? » 2017-04-11 08:08:06
- atlemo
- Replies: 6
The width and height should be flipped here, and the plate preview should be rotated 90 degrees, right?
#8 Re: Help and Support » This site can’t be reached / DNS could not be found » 2017-04-06 20:10:07
I'm still getting this after 3-4 hours of printing, seems to just shut down the service.
First this, then it just goes down completely.
#9 Re: Help and Support » This site can’t be reached / DNS could not be found » 2017-04-05 20:30:55
Thanks, that IP works. But I'm still uncertain what Online Access Key is/does?
I'm used to OctoPi, where I have always used octopi.local with no issues.
#10 Help and Support » This site can’t be reached / DNS could not be found » 2017-04-05 19:43:19
- atlemo
- Replies: 5
Hi
I have my raspberry Pi 3 running NanoDLP, and I started a print. Everything was going great, but I noticed some issues where it would sometimes drop out, as in I can't access nanodlp.local
Keep getting:
This site can’t be reached
nanodlp.local’s server DNS address could not be found.
Now, I need to stop a print but can't get back to the admin interface at all.
What can I do!?
Pages: 1