Separate names with a comma.
Signup today and join in on the fun!
I went with the hose clamp version, but a quick search resulted in these: https://www.inventables.com/technologies/bosch-colt-spindle-mount "It has a...
I just finished getting my first aluminum piece cut and I thought I would share some of my equipment and settings, trial and many errors later. Most...
I didn't add a max, I just set up a min to keep it from going through the spoiler table. There isn't really a good location for a max I have found. I...
I did the same and made a case suited to the 20x40 Vslot on the back of the gantry. [ATTACH] [ATTACH]
I'm using these http://www.kelinginc.net/KL23H51-24-8B.pdf 156 oz-in motors, wired bipolar series, so 3.6 ohms/phase. My motor power supply is 24v....
I am using the grblShield v5 with an Arduino Uno. I have a few RepRaps, so I started with a Sanguinololu but I switched to the grblShield. Overall...
What did you use for the fill material? It is defiantly a nice (and functional) touch. Finally got end stops and motion test/calibration. Next is...
Hey everyone, just wanted to say thanks for the designs and a quick plug to Chris and Bill (http://www.opensourceluthiersupply.com/) for their great...
