carl's Recent Activity
-
carl liked Robert Hummel's post in the thread Lautr3k.
Just finished up the last parts, I have the X carriage designed in my nerd just gotta make it up in sketchup and mill it :) Support plates,...
Jun 25, 2014 at 8:37 AM
-
carl liked Robert Hummel's post in the thread Lautr3k.
Little update using pics :) [ATTACH] [ATTACH] [ATTACH] Time to cut some leadscrews and design the X Axis carriage :) Edit Leadscrews...
Jun 25, 2014 at 8:37 AM
-
carl liked Robert Hummel's post in the thread Lautr3k.
Ty :) I went with 480mm 20x40 for the Z rails and also plan to use 20x40 for the X. The support rails will be the only 20x20 used so it's...
Jun 21, 2014 at 3:24 PM -
carl left a message on Robert Hummel's profile.
can you join 3D Printer DIY group Robert Hummel on facebook and show more of your laur3k build ? it should be ok as i pump the openbuild...
Jun 21, 2014 at 5:48 AM -
carl liked Robert Hummel's post in the thread Lautr3k.
And here it is at a stand still, all out of T nuts and hardware is running low. The side mounts for the Z Axis [ATTACH] All assembled :)...
Jun 21, 2014 at 5:34 AM
-
carl liked Robert Hummel's post in the thread Lautr3k.
I have decided to go with a 2 part mount using 1/4" plate. The first is the motor mount with a 30% pocket operation done on it. The secound...
Jun 19, 2014 at 6:00 AM
-
carl liked Robert Hummel's post in the thread Lautr3k.
I was going to go the same route but was told that the kit I got will drive my motors at the full 1.5 amps with heat sinking so I hope it...
Jun 19, 2014 at 3:32 AM
-
carl liked kram242's post in the thread Lautr3k.
This build is looking great Robert and I am in the mood for building a new 3D printer :thumbsup:
Jun 19, 2014 at 3:32 AM