Separate names with a comma.
Signup today and join in on the fun!
I have quite a bit of V rail in stock if you are in a hurry- www.opensourceluthiersupply.com
Glad things are coming together Serge. Hope the stuff from me came safe and sound. Shipping is a killer I think UPS has raised it's prices you can...
Well I finally got going on my Routy build and things are going together well. Impressed with the parts and the fit and finish. The place I feel...
Hi Richard- I am a new distributor for Open build and I have a limited supply of V rail in stock. I am in New York State and I charge the same prices...
Hi- I am a distributor and I finally have my web store up and I am adding parts daily. I have 20x80mm x 1500mm I received today please check out my...
Synthetos has Gsheild without the shapeoko mod. It looks like all the mod is one jumper? I could do that myself.
Thanks Vic I didn't know that the Gshield could be powered by a 24Volt power supply. I will look at the other sites. I don't hear any talk about the...
More parts came today in the mail. I am hot to get going but having trouble finding the electronic. The power supply is out of stock. And the G...
One trick I have heard of is to use heat shrink tubing to shim a bearing for a better fit in the race or plate. Electric tape is a low tech solution....
I ended up getting a delron nut like used on the Shapeoko. I bought a piece of 8MM stainless steel rod from Mcmaster and Carr. They sell bearing that...
McMaster has 6mm ID with 13mm and 19mm od. I found these but you have to buys a pack of ten http://www.vxb.com/page/bearings/PROD/kit825
There's a guy in England that is a distributor he is called Robo-Cutter Uk. Go to the openbuild store and check the news that is where the...
Gareth- Sounds like a great idea. I had an idea a while back of stacking laser cut thin plywood to create a part. If you have a laser you could cut...
I have bought regular up cut bits from this place and they will sell small orders. Prices are a little better. I use them down to 1/32" for inlay...
Being a guitar maker I cut a lot of wood from spruce to rosewood. I have gone to carbide spiral down cut bits to avoid chip out. Some people say the...
