Welcome to OpenBuilds Community

Signup today and join in on the fun!

Sign Up

Recent Content by ronniebelmar

  1. ronniebelmar
    Post

    Lautr3k

    So I got my reprinted parts and I installed everything. My y-carriage doesn't hop anymore. also put in new bearings. My problem now is the stage...
    Post by: ronniebelmar, Mar 25, 2014 in forum: 3D printers
  2. ronniebelmar
    Post

    Lautr3k

    So do I. Do you use the default settings? Is there a prefered infill?
    Post by: ronniebelmar, Mar 14, 2014 in forum: 3D printers
  3. ronniebelmar
    Post

    Lautr3k

    Do you use Slic3r?
    Post by: ronniebelmar, Mar 14, 2014 in forum: 3D printers
  4. ronniebelmar
    Post

    Lautr3k

    I too want to add a duel extruder but first I am focusing on what I got. I have a need to print complex shapes that usually do not have a flat edge....
    Post by: ronniebelmar, Mar 14, 2014 in forum: 3D printers
  5. ronniebelmar
    Post

    Lautr3k

    THX!!! I used your setting and got a much cleaner print. I think my extruder setting were off. Also, I need to tighten up my Y axis. It still hops...
    Post by: ronniebelmar, Mar 13, 2014 in forum: 3D printers
  6. ronniebelmar
    Post

    Lautr3k

    still needs some twerking!!
    Post by: ronniebelmar, Mar 9, 2014 in forum: 3D printers
  7. ronniebelmar
    Post

    Lautr3k

    I really had to slow acceleration down but.....FIRST SUCCESSFUL BUILD!!! so far :)
    Post by: ronniebelmar, Mar 9, 2014 in forum: 3D printers
  8. ronniebelmar
    Post

    Lautr3k

    I guest EEPROM set to zero. get Error: No EEPROM support compiled.
    Post by: ronniebelmar, Mar 9, 2014 in forum: 3D printers
  9. ronniebelmar
    Post

    Lautr3k

    sorry still new to this. Is there a way to read and change the firmware on the arduino? It has Repetier 0.83 firmware and I don't know all the...
    Post by: ronniebelmar, Mar 9, 2014 in forum: 3D printers
  10. ronniebelmar
    Post

    Lautr3k

    I thought it might have to much resistance in the carriage. I am able to spin the screw at the coupling with my thumb and forefinger and traverse...
    Post by: ronniebelmar, Mar 9, 2014 in forum: 3D printers
  11. ronniebelmar
    Post

    Lautr3k

    well I am the guy that bought the kit. Overall not happy with seller. Y carriage print quality was horrible. Its twisted. Also missing parts and...
    Post by: ronniebelmar, Mar 8, 2014 in forum: 3D printers
  12. ronniebelmar
    Post

    Lautr3k

    My Y carriage is very unstable. Still tweaking the unit
    Post by: ronniebelmar, Mar 8, 2014 in forum: 3D printers