Separate names with a comma.
Signup today and join in on the fun!
Private message me your address and I will check shipping cost and tell you the total
This set is called for but yes I take orders as they come. Most sets take about three days to mill, clean, tap and ship depending on my work...
Both Y plates are milled, I will try to get X done tonight Edit Milling x plates now
I only suggest it because if you plan to use an RC spindle ,12-14 vdc @10amps is optimal, running your spindle any higher will generate a lot of...
The 480mm rails go on the outside the two 450mm in between to make a square
This is really where I hit a wall in that I know very little when it comes to programing. I can make the PCB's no prob but find myself building...
I'm working on an all in 1 controller and would like to incorporate a pendent for jogging and such. The controller will be running GRBL and hopefully...
I still found myself wiping out the files now and then, just a hair out here and there :)
Just my thoughts here, everything looks cool but I would just spend the extra 15 or so bucks and get a 24v power supply from open builds for the mill...
Nothing wrong with wanting to look good while milling, also a well thought clean design helps in the long run;)
Great job! Look forward to your self upgrades :)
I don't see that being a problem, look forward to what you come up with, I have bin playing with the idea of a fish tank air pump and needle setup...
My Y axis on the OX AI is 1250mm X 900, all runs smooth by hand electronics are in the works
I don't think you would have an issue with loads of that degree myself. Mark may be more informative. I would say 4 wheels each side could easily...
Sorry that I do not have but it should be easy for you. First assemble/adjust your motor plates and make sure they ride smooth on a stick of 20x20...
Y rails = 480mm 20x20 Y rail joining braces = 450mm 20x20 Repeat for lower section of machine X rail = 500mm 20x20 Joining struts = 80mm 20x40 or...
If you are referring to the parts list extrusion length, that is just the suggested length to buy. When I get home I will measure the cut lengths I...
I will be using an arduino BOB, running GRBL and TB6600 drivers myself, really there are many options. I would say look at your budget and decide...
My build is 340x340mm cut/etching area The distance can be as far as you like as the lens is simply focused to a pin sized dot. I would say the...
Be sure to be careful if using MDF spoil boards as they will swell, the trick I find works best is a spray bottle misting the acrylic, if the mix is...
