Welcome to OpenBuilds Community

Signup today and join in on the fun!

Sign Up

Long Ox with drop in table

Discussion in 'CNC Mills/Routers' started by TahoeTim, Jun 1, 2014.

Long Ox with drop in table

Long Ox with drop in table

Discussion in 'CNC Mills/Routers' started by TahoeTim, Jun 1, 2014.

This build is a modified Ox build. The long rails are 1000mm. My build includes a solid clamping table.

  1. TahoeTim

    TahoeTim Well-Known Builder

    TahoeTim published a new build:

    Read more about this build...
    TahoeTim, Jun 1, 2014
    #1
  2. JustinTime

    JustinTime Veteran Builder

    Are you going to install a spoiler board on top of it? Without it you will cut into the alu cross pieces.
    JustinTime, Jun 2, 2014
    #2
  3. TahoeTim

    TahoeTim Well-Known Builder

    Yep, if I am routing a part that cuts through the part I will slip a spoiler board under my part.

    I didn't want to go to all the trouble of making the attached spoiler board over and over.
    TahoeTim, Jun 2, 2014
    #3
  4. kram242

    kram242 OpenBuilds Team Staff Member Builder

    Great hold down idea for this build Tim! :thumbsup:
    kram242, Jun 2, 2014
    #4
  5. winand

    winand Well-Known Builder

    Like the slotted bed!
    Just curious; the wooden bed itself is also exactly 20mm i presume?
    How did you get it flush with the 20x20 beams?
    winand, Jun 2, 2014
    #5
  6. Lee Saferite

    Lee Saferite Well-Known Builder

    Where did you get the mount for your router body?
    I'm still looking for a good one to hold my Dewalt router.
    The dewalt is just until I can afford to pick up a water cooled spindle though. :)
    Lee Saferite, Jun 7, 2014
    #6

Share This Page