OSH Park
Profile for Mattaus
Shared projects
BLF Triple Series AA Battery Pack Bottom
by
Mattaus.
2
layer board of
1.23x1.23
inches
(31.27x31.27
mm).
Shared on
March 21st, 2014 22:26.
31mm 3S AA Battery Pack Base Plate
BLF Triple Series AA Battery Pack Top
by
Mattaus.
2
layer board of
1.23x1.23
inches
(31.27x31.27
mm).
Shared on
March 21st, 2014 22:25.
31mm 3S AA Battery Pack Top Plate
7135 Based SRK Driver V1.1
by
Mattaus.
2
layer board of
1.94x1.83
inches
(49.28x46.48
mm).
Shared on
March 18th, 2014 10:14.
32x AMC7135 Based Driver For Sky Ray King Flashlights.
- D1: SOD-323
- C1:10 uF
- R1: 19.1K, 1%
- R2: 4.7K, 1%
- Processor: ATTINY13 or similar
- LED connects to the + and – pads.
- Star points 2,3 and 4 for using stock 105C firmware and mode selections.
SRK FET Based Driver
by
Mattaus.
2
layer board of
1.90x1.81
inches
(48.26x46.08
mm).
Shared on
March 13th, 2014 11:09.
46mm 20A FET LED Driver For SRK Lights.
L1: TBD FET: 70N02 D2: DIODE_MBRS540. Connects between D1 and C+ pad. Diode D1 SOD-323. C1 is 10 uF. Resistors are 19.1K and 4.7K, 1% Regulator chips are AMC7135 Processor is ATTINY13 or similar LED connects to the + and – holes. C- & C+: are for user selected large capacitor. SW+ & SW-: at for momentary switch contacts.
The driver mode configuration “stars” are marked 2 to 4 on the MCU side of the driver.
Battery plus is the large center pad on the reverse side of the board.
BLF Tiny12
by
Mattaus.
2
layer board of
0.48x0.48
inches
(12.12x12.12
mm).
Shared on
February 21st, 2014 09:51.
12mm Nanjg 105C compatible LED/flashlight driver.
Diode D1 is a BAT54. C1 is 10 uF. Resistors are 19.1K and 4.7K, 1% Regulator chips are AMC7135 Processor is ATTINY13 or similar LED connects to the + and – holes.
Outer ring is ground. Battery plus connects to + from the reverse side.
The driver mode configuration “stars” are marked 2 to 4 on the MCU side of the driver.
BLF discussion thread: http://budgetlightforum.com/node/24953#comment-550914