Breadboard Power Feeder

by Eric.
Top
Bottom

2 layer board of 0.26x0.94 inches (6.50x23.85 mm).
Shared on January 10th, 2014 01:09.

Cost: $1.20 for three.

Description:

Small board to feed power from your bench supply to a solderless breadboard.

Install a 2x2 pin header at one end, on the bottom side. Solder wires at the other end (positive to square pad). Terminate wires with red and black banana plugs. Install this slide switch on the top side. Use a small zip-tie around the notches to provide wire strain relief.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project