EasyRaceLapTimer Transponder SMD R1.2

by TimJC.
Top
Bottom

2 layer board of 0.36x0.72 inches (9.09x18.29 mm).
Shared on December 10th, 2015 01:02.

Please check out R1.4

IR transponder for multirotor (drone) racing with EasyRaceLapTimer system.

This board is intended to be powered by 5V from a spare servo connector on your receiver or flight controller. The hole in the board is for cable strain relief.

Note: ATTiny85 needs to be programmed with applicable code from EasyRaceLapTimer project.

This board has not been tested.

Parts to populate each board:

Optional (but recommended):

Helpful:

For more informaiton visit:

5V Through hole R1.1 version

Battery balance port R1.2 version

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project