AVR I2C LCD for RIG RX2

by goboxgizmos.
Top
Bottom

2 layer board of 2.83x2.42 inches (71.76x61.57 mm).
Shared on June 13th, 2014 16:22.

Still working on this.

In short it takes the output from the RX2 that would normally drive the 7 segment LED channel display and converts it to LCD.

It also doubles as a signal meter too thus bringing everything together in a single display device.

It can also switch a preamp (or other device) off and on via the relay. This too is signaled on the LCD.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project