USB Type-C JTAG Adapter

by meklort.
Top
Bottom

2 layer board of 0.95x1.69 inches (24.21x42.95 mm).
Shared on May 20th, 2017 17:09.

This board is a JTAG adapter based on an FTDI chip in a SD-card form factor.

Design has been tested with openocd and an Atmel SAMD5 board successfully. ***Note: This board does not properly specify the CC resistor for the USB Port, resulting in it not being detected properly with a usb-c to usb-c cable. A usb-c to USB-A cable works fine, however.

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project