OSH Park
Q8 44mm Tailcap Multi-cell setup with fuses
- You need to sign in or sign up before continuing.
Q8 44mm Tailcap Multi-cell setup with fuses
by
Texas_Ace.
2
layer board of
1.74x1.74
inches
(44.22x44.22
mm).
Shared on
September 29th, 2016 12:51.
This is the tailcap for the Q8. It is also setup to fit SkyRay kings.
This is a universal tailcap PCB that allows for any cell setup you can think of from 1s4p, 2s2p, 4s1p.
It uses 1210 fuses or 0 ohm jumper resistors to select the cell configuration.
It also has a place for a clicky switch, although it would not work when using it in 2s or 4s mode due to needing the pivot point for the tailcap.
The hole spacing is:
20mm from spring pad to spring pad measured as a square
37.5mm Mounting holes diagonally across the center of the board
Center pivot hole is 4mm