You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 Re: Help and Support » Z-axis doesn't work (it works on manual) » 2016-02-27 05:16:31
G99 and G100 are projector on/off commends. They send binary code to projector from Arduino.
I wanted to turn on projector 5 minutes earlier before printing starts and so I put the commend(projector on) on Gcode-start of print insted of using projector turn on/off commend.
I think I need to handle this problem too after Z-axis motor moves.
#2 Help and Support » Z-axis doesn't work (it works on manual) » 2016-02-26 09:26:09
- Wes Kim
- Replies: 16
Thank you for the releases nanodlp. I am really on it.
Now I have two problems. sequence and Z-axis.
Z-axis doesn't work after I start printing.
I use Ramps on Arduino mega to control the motors. I don't think it wiring or any electronic problem. It works pretty well on manual.
I though I probably forgot to set something about motor. I couldn't find any clues even though I looked up Setup menu and Printer profiles.
I guess I might be able to correct sequence after making Z-axis move.
If somebody know or experienced same problem, give me some advice.
Thanks for reading.
Pages: 1