PWM Pot with BAT54S Diode

by BananaGuns.
Top
Bottom

2 layer board of 0.32x0.40 inches (8.15x10.16 mm).
Shared on August 7th, 2016 15:49.

Clean up your PWM builds by fitting the diodes right to the back of the pot. This also reduced the depth of the pot/diodeassemnly to about ¼ the size it is with the pins and diodes normally.

You don’t need to use a ½" potentiometer, pretty much any pot with a staggered footprint (shaped like a triangle) will work.

Part Package
93PR10KLF VSSOP8
BAT54S SOT23

Off board - One wire connects to the diode pad on your PWM board, the other connects to the Wiper pad. If the output is full power on 0, simply flip the wired around on the PWM board.

Be sure to follow me on Instagram:

@ApexBoxMods

And check out My eBay store for completed boards!

Order board. Download. Permalink. Embed order link.

Copy this HTML into your page to embed a link to order this shared project