Micro MinimOSD PDB

2 layer board of 1.42x1.42 inches (36.02x36.02 mm).
Shared on May 5th, 2016 16:38.

Note: No clearance on standoffs is an almost guaranteed short circuit with metal standoffs. And the minim cutout is undersized. And why not have a 12v reg, since there’s space. Anyway, don’t use.

I like an OSD, but I hate wiring it. Put the Pololu reg on top or beneath the board. Fundamentally just a respin of the Atom PCB, but with bigger tracks for the power leads because the Atom PCB doesn’t look like it’d stand up to a constant 5A per motor load.

The pads are mostly laid out to be as directly wired for a SN20a as possible, but the pads for motor #1 are reversed to provide better current handling for the negative rail.

There are ground and signal “pads” near the power pads for jumping from the ESC to a second wire for running up to the FC.

Warning: Untested. Order at your own risk.

Order board. Download. Permalink. Embed order link.