OSH Park
Shared projects
FGPMMOPA6H GPS Breakout v1.1
by
Jenner.
2
layer board of
1.71x1.11
inches
(43.38x28.12
mm).
Shared on
March 14th, 2017 19:21.
Basic breakout board for the FGPMMOPA6H GPS module.
To use with a 5V FTDI cable and your computer, orient cable with RESET (green) at pin 1 on J1.
To use with 5V controllers, connect VCC, 5V_RX, 5V_TX, and GND.
To use with 3.3V controllers, connect VCC, 5V_RX, 3.3V_TX, and GND.
The Github repo has the design and parts list.
This project is released under the Open Hardware License v1.2.
E202VAR VLF Radio Receiver v1.4
by
Jenner.
2
layer board of
2.21x3.21
inches
(56.06x81.46
mm).
Shared on
March 14th, 2017 18:55.
An open source version of Renato Romero’s portable E202 VLF radio receiver, made with permission.
This board was built and verified by listening through headphones. It needs a full test of functionality, but I leave that to someone in the VLF community with the appropriate test equipment.
The Github repo has the design and parts list.
This project is released under the Open Hardware License v1.2.
Grasshopper.v01b
by
PeskyProducts.
4
layer board of
0.71x1.76
inches
(17.93x44.73
mm).
Shared on
March 14th, 2017 18:30.
Replaced SMA antenna connector with Johanson 900AT430070 chip antenna.
Power and Fan Control Board v2.0a
by
mafe72.
2
layer board of
1.07x0.99
inches
(27.13x25.15
mm).
Shared on
March 14th, 2017 17:20.
Power switch and fan control board for the Raspberry Pi mini NES, full details and schematic at https://www.facebook.com/groups/miniNESbuilders/permalink/489956341190644/
Scripts to manage this PCB can be found here:
https://www.facebook.com/groups/miniNESbuilders/516239388562339/
https://www.facebook.com/groups/miniNESbuilders/508956222623989/
Front PCB: https://oshpark.com/shared_projects/fVcUTRQC
BOM: R1=150ohm R2=10K D1=1N4001 Q1=NDD02N40 (or equivalent N-MOSFET) Fan=B2B-PH-K-S JST straight 2mm pitch
Note: Polarity on the LED is reversed, negative pole is label as positive.
loadCell_Amplifier_v0.01.brd
by
sshriya.
2
layer board of
0.99x1.20
inches
(25.07x30.48
mm).
Shared on
March 14th, 2017 15:56.
Load Cell amplifier for Futek load cells