OSH Park
Shared projects
USB-to-1-wire Interface
by
alanmitchell.
2
layer board of
1.61x2.27
inches
(40.77x57.76
mm).
Shared on
December 20th, 2016 08:08.
This project is a USB-to-Maxim 1-wire interface circuit. It was built to interface 1-wire sensors to a Raspberry Pi computer. For more details see the Mini-Monitor Project.
The Anti-Gravitator Thru-Hole Version
by
dewhisna.
2
layer board of
1.21x3.10
inches
(30.61x78.84
mm).
Shared on
December 20th, 2016 07:41.
An inexpensive through-hole remix of the Thingiverse 943091 Anti-Gravitator. http://www.thingiverse.com/thing:943091
This version is designed to be less expensive to build than the original full-size Anti-Gravitator Control Module. Most of the board was completely unused so why pay so much for a set of three boards?
Also, to make it quicker to solder together and since I have a lot more through-hole parts on-hand than surface mount, I opted to change the design to be all through-hole.
More details and pictures can be seen on my Thingiverse posting: https://www.thingiverse.com/thing:1982994.
Watch
by
brunob45.
2
layer board of
1.63x1.90
inches
(41.35x48.29
mm).
Shared on
December 20th, 2016 07:02.
ESP8266 Badge Project
by
georgestephanis.
2
layer board of
3.94x3.15
inches
(100.00x80.01
mm).
Shared on
December 20th, 2016 05:46.
A first attempt at an electronic badge.
Taco Tuesday Short BUS
by
AmmoMFG.
2
layer board of
3.25x1.75
inches
(82.65x44.55
mm).
Shared on
December 20th, 2016 04:42.
This is a Rig-Runner alternative, 6 Andersen Power Poles each individually fused with a reverse protection diode. Diodes are optional obviously.