nRF24L01+TeensyMiniAdd-On.v02y

2 layer board of 0.71x0.77 inches (17.96x19.66 mm).
Shared on August 18th, 2014 06:07.

nRF24L01+ 2.4 GHz radio add-on board for Teensy 3.1 with smaller 16 MHz crystal and in-board antenna instead of low-range ceramic antenna

Copy this HTML into your page to embed a link to order this shared project

TEMT6000 Light Sensor Breakout Board

2 layer board of 0.40x0.33 inches (10.19x8.28 mm).
Shared on August 18th, 2014 04:07.

Breakout board for the TEMT6000 ambient light sensor

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 1.36x1.26 inches (34.62x32.11 mm).
Shared on August 18th, 2014 02:22.

A pair of output filters which should help to clean up the otherwise-noisy DG1022 series.

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 0.70x1.20 inches (17.88x30.58 mm).
Shared on August 18th, 2014 02:18.

MK36000 to 28C64 adapter

Copy this HTML into your page to embed a link to order this shared project

2 layer board of 1.86x1.86 inches (47.27x47.27 mm).
Shared on August 17th, 2014 23:11.

Quad XP Footprint array using Carclo 1062X Optics, direct drive via 70N02 FET.

Single XP footprint LED, direct drive via IRLML2502 FET.

RGB XQ array using unknown reflector, each LED driven via 2 AMC7135 linear CC regulators.

Controlled via PIC16F1825 TSSOP.

Intended for MLED Firmware.

Copy this HTML into your page to embed a link to order this shared project