OSH Park
Shared projects
- You need to sign in or sign up before continuing.
RGB AMP
by
Akira76.
2
layer board of
1.24x0.53
inches
(31.45x13.36
mm).
Shared on
August 11th, 2014 14:51.
RGB AMP
36mm PDB Rev2
by
TimJC.
2
layer board of
1.42x1.42
inches
(36.02x36.02
mm).
Shared on
August 11th, 2014 12:26.
36mm Multirotor PDB
30.5mm M3 mounting holes for 36mm flight controllers like Naze32, Flip32, CC3d, etc.
Not compatible with 50mm FCs, like KK2.
Mounting holes not suitable for metal hardware.
The pin headers are added to allow the connection of a 5V UBEC to the pads above the cut out. The pads above that allow for ground, +V (~12v on 3S) and 5V out to power FPV cameras and/or video transmitter. The ground and +V pads at the bottom of the board are for supplying battery voltage to your flight controller for voltage monitoring (low battery alarm).
Please see revision 2.1 for better isolation around mounting holes.
Opendous_FT2232H
by
Tamagotono.
2
layer board of
2.71x1.71
inches
(68.81x43.38
mm).
Shared on
August 11th, 2014 05:21.
Opendous project from https://code.google.com/p/opendous/wiki/JTAG
36mm Power Distribution Board
by
TimJC.
2
layer board of
1.42x1.42
inches
(36.02x36.02
mm).
Shared on
August 11th, 2014 02:21.
36mm Multirotor PDB
Ground terminals are located in the corners, and high current items (ESCs) should be soldered to the side with the minus symbol (-). The exposed ground pads on the opposite side of the board should only be used for low current draw applications (e.g. video equipment, 3.3/5/6V UBEC, LEDs).
Positive terminals are located on the sides of the board, and high current items (ESCs) should be soldered to the side with the plus symbol (+). The exposed positive pads on the opposite side of the board should only be used for low current draw applications (e.g. video equipment, 3.3/5/6V UBEC, LEDs).
The pin headers are added to allow the connection of a 5V UBEC to the pads above the cut out. The pads above that allow for ground, +V (~12v on 3S) and 5V out to power FPV cameras and/or video transmitter. The ground and +V pads at the bottom of the board are for supplying battery voltage to your flight controller for voltage monitoring (low battery alarm).
30.5mm M3 mounting holes for 36mm flight controllers like Naze32, Flip32, CC3d, etc.
Not compatible with 50mm FCs, like KK2.
Mounting holes not suitable for metal hardware.
Please see revision 1.1 for better isolation around mounting holes.
For an option with less exposed solder pads, please see revision 2.1.
ICBM
by
mmolteratx.
4
layer board of
2.03x1.80
inches
(51.46x45.72
mm).
Shared on
August 11th, 2014 00:36.
1590B sized IC Big Muff clone board with tone bypass switch
Schematic: https://www.dropbox.com/s/s7k3489ex6y4lna/ICBM.png?dl=0